① Lamp inspection Check that the appearance of the lamps is normal, there is no trace of mechanical damage, and the lamps and lanterns are complete.
② Determine the installation location, determine the installation location and draw a line on the roof of the parking lot as needed.
③Punching and installing the suspension device Use an electric hammer to punch holes at a certain position, and penetrate into the boom or suspension hook.
④ Hanging lamps When hanging lamps, ensure that the direction is correct and the attitude is level. It is recommended to adjust the height of the lamps to between 2.8 meters and 2.9 meters, and the height difference of each lamp is not more than 10 mm.
⑤Connection The power supply line and the reserved lead wire of the lamp are reliably connected and effectively insulated.
⑥ Debug and power on, and confirm whether the power supply is normal and whether the lamps are running normally or not.
⑦The field test is tested by two triggering methods of human and vehicle. When it is confirmed that people and vehicles enter the detection range and move in the area, the lamps and lanterns will automatically switch to high brightness. After the people and vehicles leave, after a delay, the lamps and lanterns will automatically switch to low brightness. Between the lamps, the rated power brightness, sleep brightness and delay time should be basically the same.
Product runs
After the product is debugged, it can run automatically, generally without manual intervention. When the power is turned on again after a power failure, there will be a self-checking process for about two minutes, and then it will automatically enter the intelligent state.
